Page 38
Special Procedure
SP2: Fluid Identifi cation, cont’d
FROM
PREVIOUS
PAGE
UNIT OF MEASURE ?
QT
ENTER
SCROLL
PT
QT
LT
GA
FLOWMETER SETUP PER GA:?
0533
ENTER
EDIT VALUE:
REPEAT:
FLUIDS 2,3,4
to A
SCROLL
TANK REFILL
SET-UP
INVENTORY STATUS
DISPENSE LOG
SYSTEM TEST
EXIT
SCROLL
PIN#
FLUID IDENTIFICATION
SC IDENTIFICATION
COMM PORT SELECT
TIME/DATE
SYSTEM CONFIG..
EXIT
SET-UP FUNCTION: ?
EXIT
ENTER
REQUIRED ACTIVITY: ?
EXIT
ENTER
SPECTRUM 100
IDLE
TANK SIZE: ?
0500 GA
ENTER
ALARM AMT: ?
0100 GA
ENTER
INITIAL AMT: ?
0276 GA
ENTER
EDIT VALUE:
EDIT VALUE:
EDIT VALUE:
NEW
NOTE: Failure to load fl uid meter calibration
factor (pulses per gallon) for each meter into
Spectrum
TM
operating software will result in
substantial dispense quantity errors.
7
Next, enter the meter calibration factor for
the impulse meter measuring the selected
fl uid, in pulses per gallon (PPG). The default
for the model 3120-103 impulse meter is
0390 PPG. Then press “ENTER” to con-
tinue.
8
Next, enter the desired unit of measure
for the selected fl uid: “SCROLL” to high-
light the correct choice: pint, quart, liter,
gallon. Then press “ENTER” to continue.
10
Next, enter the fl uid capacity (in gallons
or liters) of the tank where the selected
fl uid is stored. Then press “ENTER” to con-
tinue.
11
Next, enter the fl uid low level limit (in
gallons) for the selected fl uid.
In oper-
ation, fl uid use will automatically trigger a
low level prompt message on the display
when fl uid in the tank is depleted below the
selected amount.
Press “ENTER” to con-
tinue.
12
Finally, enter the current amount of
fl uid stored (in gallons or liters) in the
reservoir of the selected fl uid. Then press
“ENTER” to continue.
The program will either loop back to gather
information on the next fl uid, or, if all fl uid
set-ups are complete, will return you to the
“SETUP FUNCTIONS” scroll menu.
13
The next prompt will return you to the
setup screen and ask you to select a
type of set-up function: “SCROLL” to select
“EXIT”, then press “ENTER”.
14
The next prompt will ask you to
choose the required management
activity: “SCROLL” to select “EXIT”, then
press “ENTER”. The program will return to
home position, displaying “SPECTRUM 100,
IDLE”.
