B-TEK Scales T405S, Service Manual

Page: 55 / 156

T405S Indicator Service Manual 55
6.4 System
6.4.2 Site
SitE Choose your area of operation of the indicator. Choices are: uSA , gb ,
cAn , Eu , chinA and indiA . This sets the defaults needed for your area
when the indicator is reset. See Default Values on page 54
.
.
6.4.3 Display
diSPLAy
Use this to set the following parameters for the display.
dEc.Pt This configures whether a decimal point or comma is used to
separate whole and fractional numbers.
uPdAte This configures the number of display refreshes per second.
Choices are
1 , 2 , 5 , 10 and 20 .
m-dASh If enabled, the display will show dashes during motion.
Site
USA GB CAN EU CHINA INDIA
CAUTION: Be sure you follow all local weights and measures regulations.
To reset the default settings affected by the Site selection, choose an alternate Site
selection and press
ZERO , then re-select the original Site selection.
Display
Dec.Pt Update M-dash C-zero
0.25 0.50
Off On
1 2 5 10
Decimal Comma
20
Tot Scl
Off On
Lowering the update rate can sometimes improve stability of the display in noisy
environments, e.g. vibration or wind.