B-TEK Scales T405S, Service Manual

Page: 85 / 156

T405S Indicator Service Manual 85
7.2 ENQ & B-Cast commands
7.2 ENQ & B-Cast commands
7.3 NCI commands
A ACCUM command “If ACCUM APP is active this command will generate an accumulation transaction, but it does not
perform the print function”
P PRINT command “Performs same function as pressing the PRINT key. All Ports that are binded with PRINT type
will transmit the assigned print format”
S SELECT command Performs same function as pressing the SELECT key
T TARE command Performs same function as pressing the TARE key
U UNITS command Performs same function as pressing the UNITS key
Z ZERO command Performs same function as pressing the ZERO key
F F1 command Performs same function as pressing the
F1
key
I ID command Performs same function as pressing the ID key
O OVER command Performs same function as pressing the OVER key
N UNDER command Performs same function as pressing the UNDER key
L TARGET command Performs same function as pressing the TARGET key
Upper or lower case characters will perform the same function.
W <Cr> Weight request Returns decimal weight, units and status
S <Cr> Status request Returns status.
Z <Cr> Zero request Scale is Zeroed and returns scale status.
H <Cr> High Resolution Weight request Returns decimal wt in 10x or x100 resolution with units and status.
For x100 resolution set the associated PROT > ATTR > ENQ menu value to 100.
For all other values the H command will return x10 resolution
U <Cr> Units request Changes unit of measure and then returns decimal weight in the new units with
status.
M <Cr> Metrology Raw Counts request Returns normalized raw counts and scale status.
T <Cr> Tare request Scale is Tared and returns scale status.
all else Unrecognized command Returns <Cr> ? <Lf>
See Additional token tables
on page 128
for status byte information.