B-TEK Scales T405S, Service Manual

Page: 75 / 156

T405S Indicator Service Manual 75
6.5 Ports
6.5.7 File
FiLE Use this item to configure how and where files are saved.
PAth Use this to choose where the file is saved, internally for
transfer by
FtP using an Ethernet port or to a connected uSb
flash drive.
ModE Use this to configure the file convention. Choices are:
conStAn This will create a single file that will be appended
to as new information is saved.
nuMbrd
This will create new file appended with a
sequential number for each transaction.
D_T
File
Path Mode Reset
USB FTP
Numbrd Constan
Resets
to 000001
When the FILE > PATH is set for USB, a USB flash drive can be installed into the USB
Host port and transactions will be transferred to the flash drive as they occur. If the
flash drive is not installed, transactions will be saved onto the Flash memory in the
indicator.
The size of the print format will determine the number that can be stored but with a
typical print format the indicator should be capable of storing several thousand
transactions. The saved transactions will transfer immediately when the USB flash
drive is re-installed. The message
CoPYing will display as each stored file is
transferred to the flash drive. If using the d_t file mode this could take a few seconds
to transfer each file. Do not remove the flash drive until the message
donE is finally
displayed. Stored transactions will then be cleared after the transfer.