B-TEK Scales T405S, Service Manual

Page: 78 / 156

78 T405S Indicator Service Manual
6 ADMIN level menus
l
AC Output 4 relays (20-240VAC) card
l
DC Output 4 relays (3-60VDC) card
Depending on the choice made for tYPE , a conFig menu may appear. See the Options
menu on page 76. See the Options menu on page 77 .
If USB-D or RS485/20ma card is installed:
Config
bAud Select from the list of baud rates.
d-bitS Select 7 or 8.
PAritY Select none, odd or even.
S-bitS Select 1 or 2 stop bits.
The Serial RS485/20ma and USB-D options require a Bind setting of oPtion
If Analog card is installed:
Config
LoW Set the displayed value for the lowest analog
output.
Hi Set the displayed value for the maximum analog
output.
cALib
ZEro Set the analog output zero point.
SPAn Set the analog output span point.
AdJuSt Adjustments are normally necessary to set the
zero or span output values to correlate with the
connected analog device. Pressing the following
keys will adjust the signal output as noted.
TARE increase in small increments
SELECT decrease in small increments
PRINT increase in large increments
UNITS decrease in large increments
Press ZERO to complete the analog output calibration
The Analog Output requires a Bind setting of oPtion