B-TEK Scales T405S, Service Manual

Page: 51 / 156

T405S Indicator Service Manual 51
6.3 Scale
M.intrVL Multi-interval - the division size will change immediately as it enters a new
weight range.
6.3.10 Type
tYPE Use this to select the mode and corresponding binding for the selected
scale.
ModE Select the mode from these choices:
oPtion Pick this mode if you are using the analog scale
option card.
ProtcL Pick this mode if you are using the BSQ base
connected to a serial port.
diSAbLE Pick this to disable the selected scale. This is the
default setting for Scale 2.
onbrd Pick this if you are using the onboard analog
scale. This is the default setting for Scale 1.
bind This option appears in two different forms depending on which
Mode you pick. If you pick
diSAbLE or onboArd in the Mode
menu, the bind menu does not appear.
If you choose oPtion , this selection requires a bus and card
number. For the T405S indicator, only one option card can be
installed so these values are already defaulted to bus 1 and
card 1 and do not need to be configured.
If you choose ProtcL , you must choose a binding with a
protocol selection. There are 10 available protocols and the
protocol number selected must be matched with a properly
configured protocol shown in
Protocol on page 69 .
Multi-interval is not an agency approved mode of operation.
Type
Mode
Option Protcl Disable Onbrd
Bind
Bus Card
Bus X Card X
Bind
Prot 1 Prot 10
to
If Mode is
Option
If Mode is
Protcl