B-TEK Scales T405S, Service Manual

Page: 41 / 156

T405S Indicator Service Manual 41
6.2 Calibration Procedure
Pt2-Pt9 The points are numbered 2 through 9 because, internally, the
zero reference point is point 1 and the span point is point 10.
Follow the same steps as described in the SPAN procedure to
enter each linearity point.
6.2.5 Input procedure
ZEro Use this to enter a value for the zero point.
CountS Use this to enter a zero point using ADC counts.
mV Use this to enter a zero point using a mV/V value.
SPan Accept the flashing displayed span weight ( XXXX ) or key in the span
weight that corresponds with the span ADC or mV/V value.
CountS Use this to enter a span using ADC counts.
mV Use this to enter a span using a mV/V value.
Linearity points are cleared if a new span calibration is performed.
Input
Zero Span
Counts mV
Counts mV
XXXX
The BSQ base only allows entry of Counts for Zero or Span points
The Span value is the differential value of the actual Calibration Zero and Span count
(or mV/V) values.