Atex AR950, Operation Manual

Page: 89 / 106

82
（－）
（＋）
How to Work
●
How to Charge
●
Make sure to remove the battery from the machine for charging.
Charging the battery on the machine may damage not only the
electrical parts, but also the wirings, etc.
●
When disconnecting the battery cables, disconnect the (-) side
fi rst. When connecting the battery cables, connect the (+) side fi rst.
If the above instruction is not followed and the cables are
connected
in wrong polarities, short-circuiting will occur when a tool contacts
the machine and cause fi re.
●
When connecting the battery and charger, ensure the correct (+)(-)
polarities. If they are connected in wrong polarities, the fuse will
blow and the battery will become no longer chargeable.
●
When installing the battery back into the machine, wire the
battery in the correct (+) (-) polarities as before.
Caution
●
Quick charge is a method of charge using a high charge current to quickly
make up for the electricity discharged. Quick charge is used as an
emergency measure. When the work is
fi nished, charge the battery further
using the correct method at the earliest opportunity; otherwise, the service
life of the battery will be signi
fi cantly shortened.
●
Charge the battery according to the instructions provided in the user’s
manual for the charger you are using.
1. Park the machine in a fl at place and remove the
front cover.
2. Disconnect the battery cables from (-) side at
fi rst.
3. Remove the plate fi xing battery and take out
the battery from the machine, and charge the
battery. When installing the battery, follow the
same procedure in reverse order, connect the (+)
side of the battery cables at
fi rst.
Battery cable
Plate