Atex AR950, Operation Manual

Page: 50 / 106

43
●
While the cutting blade is rotating, its height is
different from when the cutting blade is stationary
(height is higher while rotating). Also note that the
cutting height varies depending on the condition of the
ground. The right-hand table indicates the cutting
height on each cutting-height adjustment lever
position.
Cutting-height
adjustment lever
position
Cutting height
(reference)
125 125mm
105 105mm
85 85mm
65 65mm
55 55mm
45 45mm
35 35mm
Danger
●
When cutting bush in bumpy or stony ground, remove stones or
obstacles as much as possible before working.
Then adjust the cutting-height at higher cutting height than
usual for the safety. The blade may be broken, and the stones may
scatter.
Caution
●
When the front wheel falls into groove or hole, do not pull the
steering wheel or turn the steering wheel by force.
Make sure to stop the engine and try to escape from the area by
lifting the machine. Otherwise the machine may break down.
How to Work
6. If necessary, operate the cutting height
adjustment lever to change the cutting height.
7. By depressing HST pedal or shifting HST lever,
start working at the low traveling speed.
8. If loading to the engine is too high (a lot of bush were cut), lower the speed or cut
the same area twice at different cutting heights.