46
Failure to observe the following might cause the MRX-30 to malfunction:
・
Never attempt to use bent cards (so as to prevent the card from getting jammed
in the MRX-30).
・
Never attempt to force a card into or out of the MX-300.
Clocking In and Out in No Calculation Mode
During No Calculation mode (see page 61), employees will need to check the IN/OUT LED
position when clocking in and out. At that time, if the LED that is on doesn't match the column that
the employee wants punched, the employee will need to press the button that corresponds to the
desired column.
Buttons
①
and
⑥
are only enabled as long as their LED is on. If you fail to insert the card
within 10 seconds after pressing the button, the corresponding LED will go off. Also, if you
press the button again while the corresponding LED is on, it will go off and the operation will
be disabled.
1
Check LED
②
and
⑤
.
The time card will be punched in the column that
corresponds to the LED that is lit up (
②
,
③
,
④
or
⑤
). If the
LED that is on doesn't match the column that you want
punched, you need to press the button that corresponds to the
desired column. (The same applies for GO-OUT and BACK
when stepping out for a personal errand.)
2
Insert the time card.
The time card is automatically fed in and punched in the column selected in step 1.
・
If you insert the wrong side of the time card, "E-01" will appear on the display, a
two-tone beep will be sounded and the time card will not be printed.
(Card-Side-Determined function)
Check the "IN/OUT" LED.
Note
IMPORTANT!
Note