59
・
The methods discussed in this section are intended only for emergency
situations and should not be used if you have the necessary card.
・
Some of these operations involving printing on cards while the top
cover is open so be extra careful not to get your fingers caught in the
MX-300.
IF YOU LOSE A CARD ·····························
In the event that you should lose Basic Programming Card #1 or the special combination card, it is still possible to perform a few
operations using the operation panel inside the MX-300's top cover. Follow the corresponding steps to perform the desired operation:
・
Time Settings:
1
→
A
→
2
・
Employee Card Registration:
1
→
B
→
2
・
Total Hours Print:
1
→
C
→
2
If you lose the special combination card or any of the programming cards, please purchase the "MX-300
Programming Card Set" from your local Amano service dealer or representative.
1
While the power is still on, remove the top cover.
・
Prior to opening the top cover, be sure to first ground yourself (e.g.; touch a large metal object such as a steel desk) to
remove static electricity from your body to avoid shocking the MX-300. This is particular important during when the
humidity is low (winter, et al). Failure to remove static electricity could result in mechanical failure.
・
Press your thumbs (somewhat firmly) just below the LCD
display (in the location illustrated) to remove the top cover.
・
When you remove the top case, the word "OPEN" flashes on the display.
A
Time Settings
①
Press and hold down the Clock Min(+) button for two seconds.
・
When you hold down the Clock Min(+) button for two seconds, a monotone beep will sound and the current
time will be displayed.
②
Adjust the time.
・
Press the Clock Min(+) button to increase the time
one minute at a time.
・
Press the Clock Min(-) button to decrease the time
one minute at a time.
o
The moment you press either button the seconds are reset to "0."
o
Keeping either button pressed will not enable speed scrolling.
→
Go to step
2
IMPORTANT!
!
CAUTION
Press your thumbs here.
Note
ATTENTION!