Amada MF-C2000A Series, Operation Manual, Page: 254 / 272

254
MF-C2000A Series
Timing Chart
Single . . . Operation by laser controller (PANEL CONTROL)
The following diagram shows the lapse of time in the case where the laser light is
output from optical fiber using the laser controller.
*1 5s max. LD power supply ON time
*2 1s max.
LD output preparation time. In the REPEAT mode, the signal is kept
turned off for certain time after laser output to keep the average
power below the maximum rated output. The signal is not output un-
til a valid schedule is selected.
*3 Time required for the end signal to be output after a laser output
*4
Time required for outputting a signal to indicate whether the laser
energy is within the set upper limit value (HIGH) and lower limit
value (LOW) of monitor output
In *3 and *4, the output time is 20 ms but can be changed to 30 or 40 ms on the CONFIG screen.
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Laser beam is projected from
optical fiber
*4
The time set on the CONFIG screen *3
Laser beam is projected from
optical fiber
LD-ON/OFF Input *
LD ON Output
Ready Output
Laser Start Input *
(Laser light)
End Output
Monitor Normal/
Trouble Output
(*: Operation on the user side)
5s max . *1
1s max . *2