Amada MF-C2000A Series, Operation Manual, Page: 126 / 272

126
MF-C2000A Series
4 . Setting the Laser Light Output Schedule
EXPERT SETTINGS
How to see the displayed items
: Settable item
CORRECTION Sets the correction factor in the range of 0.05 to 1.00.
MONITOR SPAN Sets the display time of the temperature waveform on the MONITOR screen.
Display time of the temperature waveform = laser emission time × MONITOR
SPAN (Setting range: 1.0 to 2.0)
<Note>
In the CW waveform, the display of the temperature waveform is finished at
the time when the following operation is performed for the laser waveform
with 500 ms.
- Laser stops by the laser stop signal input within the time set in a schedule.
- The next laser output starts.
- The output setting or number of schedule is changed.
- An error occurs.
KEEP POW .
Sets the output in KEEP operation in the range of 0 to 100%.
SMOOTHING
Sets the moving average time of the measured temperature from 0.0001,
0.001, 0.01, 0.1, or 0.2 s. When the temperature change is large and it is
hard to read, increase the set time. The variation is displayed smaller.
CLOSE Returns to the ACTIVE HEAT CONTROL screen.
Time
Input
value
Smoothing
Input signal