Amada MF-C2000A Series, Operation Manual, Page: 125 / 272

4 . Setting the Laser Light Output Schedule
125
MF-C2000A Series
Chapter 2 V
arious Settings
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
ACTIVE HEAT CONTROL Screen
On the ACTIVE HEAT CONTROL screen, the active heat control function (option) is
set. The active heat control function detects the temperature of the processing part
and stops laser when it exceeds the target temperature.
How to see the displayed items
: Settable item
MODE Sets the control method for each stage of waveform. Can be selected from
following three types.
-:
The active heat control is not performed. Laser is output with the set
TIME and POWER.
SKIP: Proceeds to the next stage when the temperature reaches the target
temperature.
KEEP: Laser is turned on and off with the target temperature.
Switched each time the button is pressed. Can be set for each schedule.
EXT .OUT
END: When this button is selected, the stage end signal (Pin No.7 of the EXT.
I/O (2) connector) is output at the end of the stage. This output time is
specified in the [STAGE-END SIGNAL WIDTH] on the HEAT DETEC -
TOR SETTING screen.
HI: When this button is selected, the temperature reached signal (Pin
No.12 of the EXT. I/O (2) connector) is output while the heat detector
exceeds the target temperature.
TARGET TEMP . Sets the target temperature for the SKIP or KEEP control in the rated range of
the heat detector. Can be set for each schedule.
EXPERT SETTING
Displays the detailed setting screen for active heat control function.
X
Returns to the SCHEDULE screen.
⇒
For the common items in the upper/lower part of the screen, refer to page 81.