Amada MF-C2000A Series, Operation Manual, Page: 147 / 272

3 . Operating Procedure
147
MF-C2000A Series
Chapter 3 Laser Processing by Laser Controller (P
ANEL
CONTROL)
Introduction Part
Installation
and
Preparation
Part
Operating Part
Maintenance Part
Appendixes
<Note>
The settable laser output set value is 200 to 2000 . For the laser output value setting
(% of FLASH), set the value within the setting range .
(4) Press the "TIME [ms]" setting button of "FLASH1."
Enter the laser output time (ms) by using the numeric keypad and then press the
ENT key.
In this example, set 30.0 ms in "FLASH1."
<Note>
Set the laser output time so as to result in the following value .
"FLASH1" + "FLASH2" + "FLASH3" ≤ 500.0 ms
(5) Press the "

SLOPE" setting button.
Enter the time "TIME [ms]" required for laser light to up-slope (get gradually
stronger) in FLASH1 by using the numeric keypad, and then press the ENT key.
In this example, set 10.0 ms.
<Note>
Set "

SLOPE" so as to result in the following value .

SLOPE ≤ FLASH1
When setting "FLASH2" or "FLASH3", set the time required for laser light to down-
slow (the laser output is gradually weaker) to FLASH . Set "

SLOPE" so as to re-
sult in the following value .

SLOPE ≤ FLASH1, FLASH2, FLASH3
(6) Press the "POWER [%]" setting button of "FLASH1."
Enter the laser output value (%) by using the numeric keypad and then press the
ENT key.
In this example, set 50.0% in "FLASH1."
⇒
For the laser output value, set the ratio (%) supposing that the set laser output
set value is 100%. In this example, this set value is 50% of "SET POWER=500",
so that the actual laser output value is 250 W. In this case, even if "SET POW-
ER=250" and "FLASH1 100 ms 100%" are set, the actual laser output value is
the same.
⇒ For setting the number of continuous laser light outputs, set the number of out-
puts per second in "REPEAT" in the range of 1 to 1000 pps (pulse per second).
⇒
For setting the number of laser light outputs, set it in "SHOT" in the range of 1 to
9999. When 1 is set, a single output is performed.