Amada MF-C2000A Series, Operation Manual, Page: 123 / 272

4 . Setting the Laser Light Output Schedule
123
MF-C2000A Series
Chapter 2 V
arious Settings
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
Ex . 1) When setting “SET POWER” to 1600 and making the following waveform
The modulation width is calculated supposing that the set SET POWER is 100% .
Since the maximum set output should be more than SET POWER x POWER [%] x
modulation [%], the modulation width becomes up to 50% not exceeding 2000 W,
the maximum set output .
Ex . 2) When performing modulation from the minimum to the maximum
The modulation width whose center is 1000 W can be obtained by setting SET
POWER to 2000 and POWER to 50% . Set the modulation width to 100% .
At this time, the minimum output is not 0 W, but 100 W, the preliminary oscillation .
The preliminary oscillation is a function for stabilizing the laser oscillation . For
details, refer to "Preliminary Oscillation" on page 108 .
50
％
SET POWER 1600
100
％
800W
1600W
2000W
25%
25%
1200W
50%
50%
50
％
SET POWER 2000
100
％
1000W
2000W
100W
Modulation
width
Modulation
width