Allworx PowerFlex P810, User Manual

Page: 92 / 236

PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
4.9.2
LLDP Neighbors
This page provides a status overview for all LLDP neighbors.
To display LLDP neighbors in the web interface:
1. Navigate to Configuration > LLDP > LLDP Neighbors .
2. Check Auto-refresh to refresh the page automatically at periodic intervals.
3. Click Refresh to update manually the current page. 0.
Figure 61: LLDP Neighbor Information
NOTE
: If the switch has not discovered any LLDP devices the table display “No
LLDP neighbor information found”.
Parameter Description
Local Port The port on which the LLDP frame was received.
Chassis ID The Chassis ID is the identification of the neighbor's LLDP frames.
Remote Port ID The Remote Port ID is the identification of the neighbor port.
System Name System Name is the name advertised by the neighbor unit.
Port Description Port Description is the port description advertised by the neighbor unit.
System Capabilities System Capabilities describes the neighbor unit's capabilities. The possible
capabilities are:
1. Other
2. Repeater
3. Bridge
4. WLAN Access Point
5. Router
6. Telephone
7. DOCSIS cable device
8. Station only
9. Reserved
When a capability is enabled, the capability is followed by (+). If the capability is
disabled, the capability is followed by (-)
Management Address Management Address is the neighbor unit's address that is used for higher layer
entities to assist discovery by the network management. This could for instance hold
the neighbor's IP address.
Toll Free 1-866- ALLWORX • 585 -421- 3850 • www.allworx.com
Revised: October 30, 2013
Page 84