Allworx PowerFlex P810, User Manual

Page: 52 / 236

PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
4.2.4
ACL Status
The section describes how to display the ACL status by different ACL users. Each row describes the
defined ACE. It is a conflict if a specific ACE does not apply to the hardware due to hardware
limitations. The maximum number of ACEs is 256 on each switch.
To display the ACL status in the web interface:
1. Navigate to Configuration > ACL > ACL status .
2. Check the Auto-refresh button to refresh the page automatically periodically.
3. Click Refresh to refresh the ACL Status. 0.
Figure 31: ACL Status
Parameter Description
User Indicates the ACL user.
Ingress Port Indicates the ingress port of the ACE. Possible values are:
All: The ACE will match all ingress ports.
Port: The ACE will match a specific ingress port
Frame Type Indicates the frame type of the ACE. Possible values are:
Any:
The ACE will match any frame type.
EType: The ACE will match Ethernet Type frames. Note that an Ethernet Type
based ACE will not get matched by IP and ARP frames.
ARP: The ACE will match ARP/RARP frames.
IPv4:
The ACE will match all IPv4 frames.
IPv4/ICMP: The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP: The ACE will match IPv4 frames with UDP protocol.
IPv4/TCP: The ACE will match IPv4 frames with TCP protocol.
IPv4/Other:
The ACE will match IPv4 frames, which are not ICMP/UDP/TCP.
IPv6:
The ACE will match all IPv6 standard frames.
Action Indicates the forwarding action of the ACE.
Permit: Frames matching the ACE may be forwarded and learned.
Deny: Frames matching the ACE are dropped.
Rate Limiter Indicates the rate limiter number of the ACE. The range is 1 to 16. When disabled,
Toll Free 1-866- ALLWORX • 585 -421- 3850 • www.allworx.com
Revised: October 30, 2013
Page 44