Allworx PowerFlex P810, User Manual

Page: 115 / 236

PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
4.11
VLAN
Use the management VLAN to establish an IP connection to the switch from a workstation connected to
a port in the VLAN. This connection supports a VSM, SNMP, and Telnet session. By default, the active
management VLAN is VLAN 200, but users can designate any VLAN as the management VLAN using
the Management VLAN window. Only one management VLAN can be active at a time.
When specifying a new management VLAN, the HTTP connection to the old management VLAN is lost.
For this reason, verify the connection between the management station and a port in the new
management VLAN or connect to the new management VLAN through a multi-VLAN route
4.11.1
VLAN Membership
Users can monitor and modify the VLAN membership configuration for the selected stack switch unit,
which supports up to 4096 VLANs. This page enables for adding and deleting VLANs as well as adding
and deleting port members of each VLAN.
To configure VLAN membership configuration via the web interface:
1. Navigate to Configuration > VLAN > VLAN Membership .
2. Click Add New VLAN to add a new VLAN. Modify the VLAN ID and name. Add or remove ports by
selecting the port members.
3. Click Apply or click Reset to cancel changes and revert to previously saved values. 0.
Figure 73: VLAN Membership Configuration
Parameter Description
Delete To delete a VLAN entry, check this box. The entry will be deleted on the selected
switch in the stack. If none of the ports of this switch are members of a VLAN then the
delete checkbox is greyed out (unable to delete the entry during the next Apply).
VLAN ID Indicates the ID of this particular VLAN.
VLAN Name Indicates the name of the VLAN. VLAN Name can only contain alphabets or numbers.
VLAN name should contain atleast one alphabet.
Port Members A row of check boxes for each port is displayed for each VLAN ID. To include a port in
a VLAN, check the box. To remove or exclude the port from the VLAN, make sure the
box is unchecked. By default, no ports are members, and all boxes are unchecked.
Adding New VLAN Click to add a new VLAN ID. An empty row is added to the table, and the VLAN can
be configured as needed. Legal values for a VLAN ID are 1 through 4095.
Enables the VLAN on the selected stack switch unit when clicking on Apply . The
VLAN is thereafter present on the other stack switch units, but with no port members.
The check box is greyed out when VLAN is displayed on other stacked switches, but
user can add member ports to it.
Toll Free 1-866- ALLWORX • 585 -421- 3850 • www.allworx.com
Revised: October 30, 2013
Page 107