Allworx PowerFlex P810, User Manual

Page: 126 / 236

PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
4.11.7.2 Group to VLAN
This section enables mapping an already configured Group Name to a VLAN for the selected stack
switch unit.
To configure Group Name to VLAN mapping table via the web interface:
1. Navigate to Configuration > VLAN > Protocol-based VLAN > Group to VLAN .
2. Click Add new entry and specify the Group Name and VLAN ID. Select the ports.
3. Click Apply or click Reset to cancel changes and revert to previously saved values. 0.
Figure 82: Group Name to VLAN Mapping Table
Parameter Description
Delete To delete a Protocol to Group Name map entry, check this box. The entry will be
deleted on the switch during the next Apply.
Group Name A valid Group Name is a string of 16 characters which consists of a combination of
alphabets (a-z or A-Z) and integers(0-9). Do not use special characters. The Group
name to map to a VLAN must be present in Protocol to Group mapping table and
must not be preused by other existing mapping entry on this page.
VLAN ID Indicates the ID to which the Group Name will be mapped. A valid VLAN ID ranges
from 1- 4095 .
Port Members A row of check boxes for each port is displayed for each Group Name to VLAN ID
mapping. To include a port in a mapping, check the box. To remove or exclude the
port from the mapping, make sure the box is unchecked. By default, no ports are
members, and all boxes are unchecked.
Add new entry Click to add a new entry in mapping table. An empty row is added to the table. The
Group Name, VLAN ID and port members can be configured as needed. Legal
values for a VLAN ID are 1 through 4095 .
Toll Free 1-866- ALLWORX • 585 -421- 3850 • www.allworx.com
Revised: October 30, 2013
Page 118