Allworx PowerFlex P810, User Manual

Page: 143 / 236

PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
Parameter Description
Port The logical port for the settings contained in the same row. Click on the port
number in order to configure the schedulers.
Shapers (Qn) ShoDisplaysws "disabled" or actual queue shaper rate - e.g. "800 Mbps".
Shapers (Port) Shows "disabled" or actual port shaper rate - e.g. "800 Mbps".
Scheduler Mode Controls whether the scheduler mode is "Strict Priority" or "Weighted" on this
switch port.
Queue Shaper Enable Controls whether the queue shaper is enabled for this queue on this port.
Queue Shaper Rate Controls the rate for the queue shaper. The default value is 500 . This value is
restricted to 100-1000000 when the "Unit" is "kbps", and it is restricted to 1-
1000 when the "Unit" is "Mbps.
Queue Shaper Unit Controls the unit of measure for the queue shaper rate as "kbps" or "Mbps". The
default value is "kbps".
Queue Shaper Excess Controls allowing the queue to use excess bandwidth.
Queue Scheduler Weight Controls the weight for this queue. The default value is "17". This value is
restricted to 1-100. This parameter is only shown if "Scheduler Mode" is set to
"Weighted”.
Queue Scheduler Percent Shows the weight in percent for this queue. This parameter is only shown if
"Scheduler Mode" is set to "Weighted".
Port Shaper Enable Controls whether the port shaper is enabled for this switch port.
Port Shaper Rate Controls the rate for the port shaper. The de fault value is 500 . This value is
restricted to 100-1000000 when the "Unit" is "kbps", and it is restricted to 1-
1000 when the "Unit" is "Mbps".
Port Shaper Unit Controls the unit of measure for the port shaper rate as "kbps" or "Mbps". The
default value is "kbps".
Toll Free 1-866- ALLWORX • 585 -421- 3850 • www.allworx.com
Revised: October 30, 2013
Page 135