Allworx PowerFlex P810, User Manual

Page: 63 / 236

PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
4.5.3
MSTI Priorities
When implementing an Spanning Tree protocol on the switch that the bridge instance. The CIST is the
default instance which is always active. For controls the bridge priority. Lower numeric values have
better priority. The bridge priority plus the MSTI instance number, concatenated with the 6-byte MAC
address of the switch forms a Bridge Identifier
This section enables the user to inspect and change the current STP MSTI bridge-instance priority
configurations.
To configure the Spanning Tree MSTI Priorities parameters via the web interface:
1. Navigate to Configuration > Spanning Tree > MSTI Priorities .
2. Set the priority for the MSTI Instances. Default is 32768.
3. Click
Apply and click Reset to cancel the changes and revert to previously saved values. 0.
Figure 38: MSTI Configuration
Parameter Description
MSTI The bridge instance. The CIST is the default instance, which is always active.
Priority Controls the bridge priority. Lower numeric values have higher priority. The bridge
priority plus the MSTI instance number, concatenated with the 6-byte MAC address of
the switch forms a Bridge Identifier.
Toll Free 1-866- ALLWORX • 585 -421- 3850 • www.allworx.com
Revised: October 30, 2013
Page 55