PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
4.10.4
Auto Checking
This page enables the user to set auto detect parameters to check the link status between the PoE port
and the power device. If a fail connect is detected, the PD is rebooted automatically.
To configure Auto Checking via the web interface:
1. Navigate to
Configuration
>
PoE
>
Auto Checking
.
2. Specify the Auto Checking parameters for the ports.
3. Click
Apply
.
0.
Figure 69:
Auto Checking
Parameter
Description
Ping Check
When enabled, the function detectes the connection between the PoE port and the
PD connected.
Port
Indicates the switch port number.
Ping IP Address
The PD’s IP address to ping.
Interval Time
Time intervals at which switch sends a message to the PD. Range is 10 – 120 sec.
Retry Time
When the port is unable to ping the PD, it will retry again. After 3 failed attempts, it
will trigger failure action. Range is 1-
5.
Failure Log
Failure counter.
Failure Action
Nothing: Port continues to ping PD but no action is taken.
Reboot Remote PD: Turn off PoE port power causing PD to reboot.
Toll Free 1-866-
ALLWORX • 585
-421-
3850 •
www.allworx.com
Revised: October 30, 2013
Page 101
Summary of Contents for PowerFlex P810
