Power Quality Analyzer Model 8335
7
CHAPTER 1
INTRODUCTION
Warning
These precautions for use are imperative when using the machine. Failure to
comply with these instructions may lead to electric shocks, explosions or fire.
•
The operator will consult these instructions whenever the symbol
is displayed.
• If you use this instrument in a way which is not specified, the
protection which it provides may be compromised, putting you in
danger.
•
When removing or inserting the battery and/or SD card, ensure that
the measuring leads, sensors and power cord are disconnected. The
unit must be disconnected and powered down.
•
The unit must not be used if the “battery/SD card” housing is absent,
damaged or incorrectly fitted.
•
The safety of any system incorporating this instrument is the
responsibility of the system assembler.
•
For your safety, only use the leads and suitable accessories delivered
with the instrument: they comply with the norm IEC 61010-031 (2002).
When the sensors or accessories of lower voltage and/or category are
connected to the unit, these lower voltages and/or categories become
applicable to the entire set.
•
Before using the PowerPad
®
always check that the leads, sensors and
accessories are in perfect condition. If anything appears damaged
(even partially) it must be repaired or scrapped.
• Comply with the specified environmental conditions.
•
It is advisable to use individual protective safety devices when the
environment in which the unit is used require them.
• This unit must be used for CAT IV installations, for voltages that do not
exceed 600V
AC/DC
in relation to the ground (per IEC standard 61010-
1) or for voltages that do not exceed 1000V for CAT III installations.
Never use voltage networks or categories greater than those
mentioned.
•
Only use power cords and battery packs supplied by the manufacturer.
They have specific security mechanisms.
• Comply with the limits of the accessory or sensor safety mechanisms.
Do not keep hands close to unused terminals.
• Certain current sensors cannot be inserted and removed from bare
conductors under a dangerous voltage: consult the sensor’s manual
and comply with handling instructions.
Shop for AEMC products online at:
1.877.766.5412
www.
PowerMeterStore
.ca
