ADEMCO VISTA-100, Installation Instructions Manual

Page: 94 / 208

– 84 –
Section 16: EVENT LOG OPTIONS
This section provides the following information:
• General information about the Event Log
• Event Log printer connections
• Programming Event Log options
• Displaying/Printing the Event Log
General Information
This system has the ability to record up to 224 events of various types in a history
log. Each event is recorded in one of six categories with the time and date of its
occurrence (if real-time clock is set). These categories are:
• Alarm
• Supervisory/check
• Bypass
• Open/close
• System conditions
• Test
The log may be viewed (Display Mode) on an alpha keypad, or can be printed
(Print Mode) on a serial printer (connected to the system via a 4100SM Serial
Interface Module.
Event Log Printer Connections
The VISTA-100's event log can be printed on a local serial printer. If used,
program field 3*19 must be set to "1."
This setting overrides the functions selected for INPUT 1 and OUT 2 made in
field 3*20.
Connect a UL EDP Listed serial printer to the J2 connector using an Ademco 4100SM
Interface module as shown in
Figure 23 .
1 2 3 4 5 6 7 8 9
INPUT 1
GROUND
OUT 1
OUT 4OUT 7OUT 3OUT 6OUT 2OUT 5
J2 CONNECTOR
(VIOLET) (GRAY) (YELLOW) (WHITE) (RED) (GREEN) (BROWN) BLUE BLACK
4142TR CABLE
8
7
6
5
4
3
2
1
+ PWR
– (GND)
RXD
not used
not used
not used
not used
DTR
BLUE RED WHITE
10 FT.
CABLE
SUPPLIED
WITH 4100SM
SERIAL PRINTER
SET FOR 8 DATA BITS
NO PARITY
1 STOP BIT
300/1200 BAUD
HARDWARE HANDSHAKE
USING DTR SIGNAL
USE GENDER
CHANGER SUPPLIED
WITH 4100SM IF
PRINTER HAS DB25
MALE CONNECTOR
+ (TO TERM 11)
– (TO TERM 12)
▲
▲
TO
AUX PWR 1
OUTPUT
4100SM JUMPERS
(CUT TO SET RESPECTIVE SIGNAL FLOATING)
COLOR FUNCTION PIN#
RED CD 8
BLUE CTS 5
WHITE DSR 6
4100SM
NOTE: IF EARTH GROUND FAULT SENSING IS ENABLED
– YOU MAY GET AN EARTH GROUND FAULT INDICATION IF YOU USE
A PRINTER OR PC) WHICH HAS A 3 PRONG, GROUNDED POWER
CORD. IF THIS OCCURS, FIRST VERIFY THAT PIN 1 (CHASSIS
GROUND) IS ISOLATED FROM PIN 7 (SIGNAL GROUND) ON THE
4100SM'S RS 232 CONNECTOR (EARLY PRODUCTION VERSIONS OF
THE 4100SM-ADT HAVE AN UNMARKED, 3/8" LONG, BARE WIRE
JUMPER LYING NEAR THE PIN 1 SIDE OF THE RS232 CONNECTOR
WHICH MUST BE CUT TO ISOLATE THESE PINS). THEN VERIFY
THAT THESE PINS ARE ISOLATED ON YOUR PRINTER'S RS232
CONNECTOR. FOLLOW THE INSTRUCTIONS PROVIDED WITH
YOUR PRINTER TO ISOLATE THESE PINS IF REQUIRED.
Figure 23: Event Log Printer Connections
The printer must be configured as follows:
• 8 data bits, no parity, 1 stop bit
• 300 or 1200 baud (1200 preferred)
•Hardware handshaking using DTR signal
www.PDF-Zoo.com
firealarmresources.com