ADEMCO VISTA-100, Installation Instructions Manual

Page: 174 / 208

– 164 –
Section 26: SETTING THE REAL-TIME CLOCK
This section provides the following information:
• General information about the real-time clock
• Setting the time and date
General Information
This system provides a real-time clock, which must be set in order for the
system's event log to keep track of events by time and date. It must also be
set in order to execute scheduling programs (time-driven events).
Use a 6139/6139R alpha keypad to set the real-time clock, or set the clock
via the Downloader software. Only users with installer or master authority
level can set the real-time clock.
Setting the Time and Date
1. Enter installer or master code + # 63. Typical display shows
TIME/DATE –– THU
12:01 AM 01/01/90
2. The day of the week is automatically calculated based on the date
entered. Time and date entries are made by simply entering the
appropriate hour, minute, month, day and year.
Press the
✴
key to accept the entered value. The cursor then moves to
the right.
Press the
✴
key to move the cursor to the left of the display, to the
previous position.
Enter the correct hour then press
✴
to move to the minutes and make
the correct entry.
Press
✴
again, then press any key 0-9 to set AM/PM. Press any key
again to change AM to PM, or PM to AM.
Press
✴
to move cursor to the month position and enter the correct
month using a 2-digit entry.
Press
✴
and enter the correct date.
Press
✴
and enter the correct year.
3. Exit clock mode by pressing the
✴
key after the cursor is in the year
position.
www.PDF-Zoo.com
firealarmresources.com