ADEMCO VISTA-100, Installation Instructions Manual

Page: 134 / 208

– 124 –
Zone Descriptors
1. Select ZONE DESCRIPTOR mode.
The keypad keys perform the following functions:
[3] Scrolls both alphabet and actual words in ascending alphabetical order.
[1] Scrolls both alphabet and actual words in descending alphabetical order.
[2] Adds or removes an "s" or " 's " to a vocabulary word.
[6] Switches between alphabet and actual word list; used to accept entries.
[8] Saves the zone description in the system's memory.
[#] # plus zone number displays the description for that zone.
2. Enter the zone number to which you want to assign a descriptor.
Ex.. Key *001 to begin entering the description for zone 1, (key *002 for zone
2, *003 for zone 3 etc.). The following will be displayed: * ZN 001 A.
Note that the first letter of the alphabet appears after the zone number, and
that the zone number is automatically included with the description.
3. Enter the descriptor for that zone.
Use one of two methods as follows:
(assume, for example that the desired description for zone 1 is BACK DOOR)
a) Press [#] followed by the 3 digit number of the first word from the fixed
dictionary shown later in this section (e.g., [0][1][3] for BACK).
Press [6] in order to accept the word and proceed, or press [8] to store
the complete descriptor and exit, or...
b) Select the first letter of the desired description (note that "A" is already
displayed). Use the [3] key to advance through the alphabet and the [1]
key to go backward.
Press the [3] key repeatedly until "B" appears (press [1] to go backwards
if you happen to pass it), then press key [6] to display the first available
word beginning with B.
Press the [3] key repeatedly to advance through the available words until
the word BACK is displayed.
To add an "s" or " 's," if you need to, press the [2] key. The first depression adds
an "s," the second depression adds an " 's, " the third depression displays no
character (to erase the character), the fourth depression adds an " s," etc.
4. Accept the word.
To accept the word, press the [6] key, which switches back to alphabet list for
the next word, or press [8] to store the complete descriptor and exit.
5. Select the next word.
For selection of the next word (DOOR), repeat step 3a (word #057) or 3b, but
selecting the word "DOOR".
To accept the word, press the [6] key, which again switches back to alphabet
list.
6. Store the descriptor.
When all desired words have been entered, press key [8] to store the
description in memory.
7. To review the zone descriptors, key [#] plus zone number (e.g., #001).
To edit zone descriptors, key [*] plus zone number (e.g., *001)
8. Exit zone description mode: enter 000.
www.PDF-Zoo.com
firealarmresources.com