Q00180 Rev B
Page 198 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
6)
Reassemble the Scanner Deck area, by reversing the removal procedure.
7)
Slide the chassis cosmetic sleeve and insert panel back into place on their respective spring clips.
Verification of Display, Speakers, and Microphone:
STEPS:
1)
Reconnect the main AC power cord from the rear of the SmartCart SP or plug into the wall source.
2)
Place AC circuit breaker, located at the rear of the SmartCart SP, in the “ON” position.
3)
Ensure the
z.one
is docked in the SmartCart SP.
4)
Energize the SmartCart SP (
Ultra
System).
5)
Verify that the LCD display is functioning correctly by watching the boot and verifying that
normal imaging is displayed after fully booted.
6)
Attach a transducer (if not already connected) and enable PW mode.
7)
Turn PW Gain up to obtain a filled in spectral trace with excess noise (this will generate white
noise for the speakers)
8)
Turn the Volume up (Clockwise) and verify that the white noise is audible from both speakers.
9)
If possible – scanning with actual Doppler flow is ideal, but not required.
Содержание Z.one Ultra SP
Страница 1: ......