ZONARE Z.one Ultra SP, Руководство по обслуживанию, Страница: 121 / 244

Q00180 Rev B Page 121 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
STEPS:
1. Following the steps below, using the front panel display menu and Jog Dial control, configure
the initial user settings on the UP-D897 printer to match those shown in Figure 1, on the
following page.
“LOCK”ALERT
The MENU operations on the Sony UP-D897MD printer have a special hidden “ LOCK ”
function that if active will completely disable making any changes to the menu settings on the
printer.
IF the printer is currently in a “LOCKED” mode, a message “ LOCK ” will appear in the menu
display and an alarm “Beep” will occur, when attempting to make any menu changes.
To toggle the “LOCK” function on/off, do the following:
1) Power OFF the printer
2) Press and Hold the Jog Dial (push/enter) switch
3) Power ON the printer, while keeping the Jog Dial switch depressed until one of the
two messages listed below appear in the display menu. Repeating this power cycling
process will toggle between the lock/unlock state.
-
“ UNLOK”
-
“ LOCK ”
2.
To bring up the setup MENU, “Press” the jog dial control (labeled “PUSH ENTER”).
3.
Use your finger to “Roll” the jog dial control until the desired setting for configuration is
shown in the display window.
4.
“Press” the jog dial control to select the offered setting for modification.
5.
“Roll” the jog dial control until the desired value is displayed in the window.
6.
“Press” the jog dial control to store the displayed value as the new setting.
7.
Repeat the above “Roll”/”Press” steps for configuring each of the remaining user settings into
the UP-D897.