Q00180 Rev B
Page 188 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
9.
Tilt the top of the display towards the rear of the cart to support the LCD Display while
removing the last screw.
10.
Taking weight off the display, slide it off the threaded studs on the metal hinge assy.
11.
While still supporting the display, gently remove the video cable from the display (this may
need to be gently pried away with a screwdriver)
12.
Once the cable is free, set the display aside and prepare for installation.
Installation:
STEPS:
1.
Reconnect the Display Cable to the connector on the display.
2.
Slide the excess cable under the plastics and route in the same fashion prior to removal
3.
Align the display (4 threaded shafts) with the metal hinge assy. Route the display cable
carefully in the notch on the left of the hinge to avoid cable damage.
4.
Reattach the display arm ground cable to the bottom-left stud
5.
Reinstall the four 9/32” nuts and tighten. Ensure that the display cable and ground cable are not
pinched.
6.
Using the long straight slot screwdriver – tighten the display cable retention screw. (See Figure
1 – Location A)
7.
Reinsert the display hinge plastic cover –
•
Insert the bottom piece first, aligning the screw holes and cable
•
Slide the top cover down
8.
Tighten the four (4) Phillips-head screws that are retaining the plastic display hinge back
cover, and remove cover and insert.
System Verification:
STEPS:
Содержание Z.one Ultra SP
Страница 1: ......