ZONARE Z.one Ultra SP, Руководство по обслуживанию, Страница: 137 / 244

Q00180 Rev B Page 137 of 244
"Note: Copies are uncontrolled documents - For revision verification see the Master Documentation List"
16.3 SCAN MODULE: Standard Software Installation/Upgrade Procedure
ATTENTION
The Scan Module MUST be docked in the Cart in order to perform a Standard
(user setting auto backed-up/restored). Any software install performed with the
Scan Module undocked, will execute as a “Clean” install process (no user
settings retained).
1.
Connect a transducer to the Scan Engine (if not currently attached)
2.
Press the Power On/Off button to power the system on
3.
Allow the system to complete a normal boot operation (less then 1 minute)
4.
Insert the USB Memory Stick (containing system software installer files) into any one of the four
USB ports at the rear of the SmartCart, pressing lightly to ensure it is seated in the connector
5.
An initial software install alert message screen should appear on the LCD display
6.
To begin the software install process, at each of the two (2) alert screens, press the “SELECT”
key
NOTE : If it is determined that the software revision of the USB Memory Stick is not the
desired version for installation, and it is desired to abort (select the “NO” option)
the install operation (or abort it for any other reason), press the “BACK” key,
then manually remove the USB Memory Stick..
14.
The following initial software installation screen should appear, and be displayed for a few
seconds on the LCD Display
15.
A final “ Welcome to Install ” screen should appear
16.
Press the “SELECT” key again to begin the software installation process.
17.
The in-process installing status screen should appear, with a bar graph indicating a dynamic
percent completion status