Zener SMARTSTART 6000, Инструкция по эксплуатации

Страница: 23 / 57

Programming
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 20
Menu Navigation
D01 Menu Access:
Sets the desired user access to menu.
Selection: Disabled; Setup; Read only
Default: Setup
To save changes
To exit without saving
If the menu access is disabled a user access code is
required to access the menu. The access code is 1470.
D02 Default Screen:
The default screen is the dashboard screen that
the Soft Starter will return to ‐ on power up, exit or
time ‐ out from the menu.
Selection: Overview; Thermal; Electrical; Power;
Volt imbal; Curr imbal; Counters;
meters; clock/net
Default: Overview
To save changes
To exit without saving
D03 Bargraph Var.:
Sets the bargraph variable to monitor & Display.
Selection: Mtr current; Mtr Torque;
Mtr Thermal; SCR Thermal; Active
Power; Power Factor
Default: Mtr Current
To save changes
To exit without saving
D04 Bargraph FS.:
Adjust the full scale of the bar graph meter as a
percentage.
Selection: 100;120;150;200;300;400;600
Default: 300%
To save changes
To exit without saving
Setup Menu
1 Display
MENU ACCESS
Read Only
LOGIN CODE
> 1470
3 sec
* Press <Enter> for 3 seconds.
Setup Menu
1 Display
Esc
Setup Menu
2 Motor
Setup Menu
3 Control
Off 0V
0%
Setup Menu
4 Protection
Setup Menu
5 Reset /Restarts
Setup Menu
6 Input
Setup Menu
7 Output
Setup Menu
8 Advanced
Setup Menu
10 Command
Dashboard screen (1 of 11)
Enter
Refer to Page 20
Refer to Page 21
Refer to Page 21
Refer to Page 23
Refer to Page 27
Refer to Page 26
Refer to Page 27
Refer to Page 29
Refer to Page 32
Setup Menu
11 Starter Diag
Refer to Page 32
Setup Menu
9 Network
Refer to Page 31 &
the ‘SS6000 Network
Guide’
Setup Menu
12 Network Diag
Refer to Page 33