Zener SMARTSTART 6000, Инструкция по эксплуатации

Страница: 27 / 57

Programming
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 24
P03 Ph Rotation:
Selectable phase sequence protection to inhibit
motor operation if a prohibited phase sequence is
detected (ie. reverse operation). Ideal for pumping
applications.
Range: Ignore; 1 ‐ 2 ‐ 3; 3 ‐ 2 ‐ 1;
Default: Ignore
To save changes
To exit without saving
P10 Acc Overtime :
To enter submenu to modify
To exit sub menu
P11 Overtime Alarm:
Protection against the start time exceeding the
preset acceleration or ramp time.
Range: off; trip; warn
Default: off
To save changes
To exit without saving
P12 Overtime Del:
The time exceeding the set ramp time before a trip
on Accel overtime occurs.
Range: 5 – 300 secs
Default: 120s
To save changes
To exit without saving
P20 Volt Imbal :
To enter submenu to modify
To exit sub menu
P21 Volt Imbal Alarm:
Provide protection against a supply voltage imbalance.
Range: off; trip; warn
Default: trip
To save changes
To exit without saving
P22 Volt Imbal Level:
Adjust to set the voltage imbalance threshold, as a
percentage of the average phase voltage.
Range: 5 – 25%
Default: 25%
To save changes
To exit without saving
P23 Volt Imbal Delay:
Adjust to set a delay for the voltage imbalance trip.
Range: 0– 5 seconds
Default: 5 s
To save changes
To exit without saving
P30 Curr Imbal:
To enter submenu to modify
To exit sub menu
P31 Curr Imbal Alarm:
Protection against a current imbalance.
Range: off; trip; warn
Default: trip
To save changes
To exit without saving
P32 Curr Imbal Level:
Set the current imbalance threshold, as a
percentage of the average phase current.
Range: 5 – 25%
Default: 25%
To save changes
To exit without saving
Status
Level
Delay
P20 Volt Imbal
Trip 25% 5s
Status
Level
Delay
P30 Curr Imbal
Trip 25% 10s
Trip/off
Over Time Delay
P10 Accel OverTime
Trip 120s