Zener SMARTSTART 6000, Инструкция по эксплуатации

Страница: 34 / 57

Programming
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 31
An optional ‘Start’ function is also selectable as a digital
input. This is a latching input, which is unlatched by a
stop control input, deactivating the enable input or a
trip.
Level Sense: The default setting when using the enable
input to run the soft starter. For ‘power ‐ up’ start with
line supply to function, ‘level sense’ must be selected.
Also used for 2 wire run/stop control using the digital
input ‘Start’ and enable input. (may be used in
conjunction with the ‘stop’ or ‘coast’ input).The start
signal must be present until motor commences start.
Edge Sense: Will only start
with an edge trigger. This is
the recommended setting for 3 wire start/stop control.
May also be used to prevent an unexpected start, if
‘stop/coast’ is restored and enable/start input signal
remains active.
Refer to page 14 more wiring configuration.
Refer to pages 26 ‐ 27 for selection of digital inputs and
also page 34 for description of the digital input
variables..
A61 Try Tiny Motor
Allows a test of the starter using a small test
motor or motor smaller than the starter is rated.
Range: Enable/Disable
Default: Disable
To save changes
To exit without saving
The Smartstart
®
6000 will trip on motor loss if motor
current falls below 15% of the entered FLC. This creates
a problem for workshop testing or fault finding. If ‘Try
Tiny Motor’ is enabled a start is allowed which ignores
this protection. When the control supply is removed
this automatically resets to ’disabled’.
Below are the menu parameters that may require
adjustment to allow communication to take place with
other devices. The Communication setup must be
completed and checked before communications can
begin. For more comprehensive instructions and
mapping details refer to the corresponding ‘SS6000
Networking guide’.
N01 Net protocol
Select/enable the desired Communications
protocol.
Range: Disable; Modbus RS485: Modbus TCP
Default: Disable
To save changes
To exit without saving
N02 Net Control (RS485 & Ethernet)
Select desired operation on a network control
timeout.
Range: Disabled; Stop On T/O; Trip On T/O
Default: Disable
To save changes
To exit without saving
N03 Net Timeout (RS485 & Ethernet)
Adjust for the time delay for the timeout function.
Range: 0.1 – 60secs
Default: 2.0sec
To save changes
To exit without saving
N04 Net Config
Set for desired operation for communications .
Range: All settings; disabled, display only;
Adj ramps; Inputs/Outputs; Restart
Default: All Settings
To save changes
To exit without saving
N10 RS485 Addr (RS485 only)
Adjust to the desired network address value for the
soft starter. Each device on the bus must have a
unique address.
Range: 0 ‐ 247
Default: 0
To save changes
To exit without saving
Setup Menu
9 Network