Zener SMARTSTART 6000, Инструкция по эксплуатации

Страница: 29 / 57

Programming
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 26
P61 Under torque Alarm:
Provide protection against under ‐ torque. This
protection is not active during the accel & decel
period.
Range: off; trip; warn
Default: off
To save changes
To exit without saving
‘Trip’: The soft starter trips, stops the motor and indicates
an ‘Under Torque trip’. The Trip relay will change state if
selected.
‘Warn’: The soft starter does not trip or stop the motor. See
D05 & D06 for more information regarding warning alarms.
P62 Under Torque Level:
Adjust to the desired trip threshold, as a percentage
of nominal torque.
Range: 10 – 100%
Default: 10%
To save changes
To exit without saving
P63 Under Torque Delay:
Adjust to set the time period that the torque must
fall below the threshold before a trip occurs.
Range: 1 ‐ 90 seconds
Default: 10 s
To save changes
To exit without saving
P70 Over Torque (Electronic Shear Pin):
Electronic Shear Pin or protection against over
torque. This protection is not active during the accel
& decel period.
To enter submenu to modify
To exit sub menu
P71 Over Torque Alarm:
Provide protection against excess torque. This
protection is not active during the accel & decel
period.
Range: off; trip; warn
Default: off
To save changes
To exit without saving
‘Trip’: The soft starter trips, stops the motor and indicates
an ‘Over Torque trip’. The Trip relay will change state if
selected.
‘Warn’: The soft starter does not trip or stop the motor. See
D05 & D06 for more information regarding warning alarms.
P72 Over Torque Level:
Adjust to the desired trip threshold, as a percentage
of nominal torque.
Range: 80 – 250%
Default: 100%
To save changes
To exit without saving
P73 Over Torque Delay:
Adjust to set the time period that the torque must
exceed the threshold before a trip occurs.
Range: 0 ‐ 30 seconds
Default: 10 s
To save changes
To exit without saving
R01 Manual Reset
Activate or de ‐ activate the manual reset ie. The reset
on the local console.
Range: Enable; Disable
Default: Enable
To save changes
To exit without saving
R02 Power Reset
Activate or de ‐ activate reset on removal of control
supply.
Range: Enable; Disable
Default: Enable
To save changes
To exit without saving
Status
Level
Delay
P70 Over Torque
Trip 100% 5s
Setup Menu
5 Reset / Restarts