Zener SMARTSTART 6000, Инструкция по эксплуатации

Страница: 54 / 57

Appendix D
Data Logger Option Board
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 51
IMPORTANT: The SD card must only be inserted & removed when control power is off.
Operation:

With the control power to the soft starter off. Insert the SD card.

Power up the control circuit. The Data Logger is now operational.
The soft starter will create 2 files onto the data card:
i) .txt file ‘config.txt’ , which logs the Baud Rate and Data Format.
ii) .txt file. This is where the data will be stored. A new text file will be created each time the control
supply is cycled or can save data to the one text file. (see over page on instructions on how to
modify this).

The text file may be deleted on a computer at any stage, and a new file will be created.

The text files may be removed, copied and/or sent via email to Zener for analysis should a problem exist.
Modifying the config.txt file:
To change the logging behavior, write over the last digit (1) or the fourth digit (2) and save the changes.
(1)
(2)
This digit sets the logging behavior as follows:
0 = Creates a new data file when power is cycled
1 = Saves data is same file ‘SEQLOG.txt’
= 1 ; Single storage TXT File
= 0 ; Multiple storage TXT Files
Code Explanation:
The data files can be open and
read using ‘Notepad’ or similar
application.
Refer to the SS6000 Data Logger
Reference Manual (I0057) for a
detailed description of the data
logged and associated codes.