Zener SMARTSTART 6000, Инструкция по эксплуатации

Страница: 37 / 57

Programming
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 34
Table 1: Output Relay
Functionality
Table 2: Analogue Output Functionality
Table 3: Digital Input Functionality
Relay Function
Selection: Description
Line Ctrl Control for Line Contactor
Bypass Ctrl Control for Bypass Contactor
Accel Ramp Starter in acceleration ramp mode
Decel Ramp Starter in deceleration ramp mode
Ramping Starter in Ramp Mode
Up to Speed motor is up to speed
Motor On Motor is running
Trip Alarm A trip alarm is active
Mtr Loss
Output phase(s) open circuit/motor
isolated
Freq Error Supply frequency range exceeded
Bypass FLT Bypass contactor failed
STR OL Trip Starter reached overload level
Mtr OL Trip Motor reached overload level
Mtr OT Trip Motor thermistor/switch trip active
Ph Rotation Rotation trip active
Dig In Trip Digital input trip active
Over time Over time trip active
Volt Imbal Voltage Imbalance trip active
Curr Imbal Current imbalance trip active
Under Current Under current trip active
Over Current Over Current trip active
Under Torque Under Torque trip active
Over Torque Over Torque trip active
Warning Alarm A warning alarm is active
TOL Warning Motor Overload warning alarm
Regen. Mode
Soft starter is operating in
regeneration mode
AR Pending Waiting for restart (time)
AR Lockout Restarts exhausted – starter tripped
ESO Proof In ESO and current detected
Timer Relay Timer function is active
Fan Control Fan is ON
Test (ON) Turns relay on
Brake Fault Fault with external mechanical Brake
Analogue Output
Selection: Description
Mtr Torque Estimated torque produced in motor
Mtr Thermal Estimated Motor temperature of over load
STR thermal Soft Starter temperature
Active power Power consumed kW
Power Factor Power Factor
Mtr Current Motor Current
Test (100%) Maximum output
Digital Input
Selection: Description
Reset
Attempts to reset a Smartstart trip/fault
condition. Motor may start immediately on
successful reset. A delay can also be
configured.
Trip
Trips the Smartstart after a configurable delay.
Ideal for external pressure/flow switch.
Start
Enable this function where 3 wire start/stop
control is required. The start request is latched
once the motor starts. Use the enable or ‘stop’
input to a N/C stop button, to unlatch. Edge or
level sense may be used.
Stop
Initiates a motor stop with the configured decel
profile. A delay may be incorporated.
Coast
Forces a free wheel stop from any operating
state. Optional delay
Local
Forces local control and disables network
control
Par2
Activates the Par2 start parameters for the next
ramp (Accel or Decel).
ESO
Essential Services Override:
This feature is designed for systems that must
operate in the event of an emergency (eg. Fire
Mode). ESO overrides most protection and
input conditions to run the motor.
Brake ON
Feedback from switch that indicates the
position of an external mechanical Brake
See Page 35 for more details.