Zener SMARTSTART 6000, Инструкция по эксплуатации

Страница: 53 / 57

Appendix D
Data Logger Option Board
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 50
Description:

The Data Logger Option Card provides a SD Card slot to record the soft starter’s parameters and operating data.
1. Operating data is logged at the following rates:
i) A rate of 1/10second during acceleration and Deceleration.
ii) Every 10 seconds during running.
iii) Every 10seconds when in idle mode. ie. control supply ‘ON’ but starter not running.
2. The Soft Starter parameters are logged onto the data card when the unit is powered and if any
parameters are changed.

The data is stored as a text file (.txt) on to the SD card inserted. The SD card should not be removed while
running or a short period after as recent data may be lost.

The data may be read using ‘Notepad’ or other application capable of reading text files or use of a custom
designed application to extract and report the data required. Included is a simple application that extracts
and reports basic operating variables.
.
SD Cards Accepted:
Standard SD Card; Micro SD Card with Adapter
Installation:
1. Remove the top cover. There are 4x hex type screws holding the top cover in place.
2. The Option Board plugs into the control board into the socket marked ‘OPTION’ located on the right hand side
of the control Board.
3. There are 2 nylon spacers and 4x 2.5mm screws supplied to secure
the option card in place. The Control Board will need to be carefully
removed to access the underside to fit the nylon spacers.
Carefully cut out the label marked ‘SD Card’.
4.
Return the control board ensuring all connectors/plugs are secure and screws in place. An insulation piece should
be positioned over the gate leads (3x connectors located at the top end of the control board).
If the SD card has a write
protect tab ensure it is not in
the lock position.
NOTE: Earlier Data Logger PCB’s could accept
1G or 2G SD cards only
Nylon Spacers
M2.5 Screw