Zener SMARTSTART 6000, Инструкция по эксплуатации

Страница: 33 / 57

Programming
Technical Manual: Smartstart
®
6000 IMI0042 rev K
Page 30
To save changes
To exit without saving
A31 Decel Profile
Select the type of deceleration profile to match
the type of load or application.
Range: Linear; Squared
Default: Linear
To save changes
To exit without saving
A32 Decel Control
Select the type of deceleration control to suit
the load or application. Torque control will
provide greater control over the deceleration /
stopping of a motor under load.
Range: Torque; Voltage
Default: Torque
To save changes
To exit without saving
A41 Motor Mtr OL Reset
Enter the level for the Motor over load protection
to allow a reset.
Range: 10 – 100%
Default: 75%
To save changes
To exit without saving
A42 Str OT Reset
Enter the level for the Starter over temperature
protection to allow a reset.
Range: 40 – 90° C
Default: 60° C
To save changes
To exit without saving
A43 Warning Level
Set the threshold level for warning alarms with
protection based on level only. Eg. Thermal trips
such as Motor Overload. Enter as a %.
Range: 50 ‐ 100%
Default: 90%
To save changes
To exit without saving
A44 Warning Delay
Set the warning threshold for protection based on
a time function. Eg. Overcurrent. Enter as a % of
the trip delay time.
Range: 25 ‐ 100%
Default: 50%
To save changes
To exit without saving
Notes:
1) If the soft starter is configured to display warning
alarms(see D05 & D06) this sets the threshold point
which a warning alert is displayed.
The screen will display: WARNING followed by a code
and description. Eg. W33 MTR OVERCURR
2) If a relay is configured for ‘Warning’ then the relay
will change state.
A51 Motor Stator
Enter Details of the Motor Stator.
Range: 1.5 – 5.0%
Default: 3.0%
To save changes
To exit without saving
A52 Min off time
Adjust this parameter to provide a minimum off
time before a start is permitted. This will limit the
amount of starts per hour and allow the soft starter
(or Motor) to cool before a restart.
Range: 0 – 600mins
Default: 0.0
To save changes
To exit without saving
** The motor may restart after time lapsed if enabled**
A53 Start logic
This parameter sets the operation of a start signal,
whether it senses level or an edge of a start signal.
Range: Edge sense ; Level sense
Default: Level sense
To save changes
To exit without saving
The enable input is generally used as the level sensed run
input for the soft starter.