•
Trigger Delay Reach
→ Defines if the trigger delay setting of the first 6 tracks should affect
only the trigger column (Column) or all trigger commands (Full)
•
Reset FX on Seq stop
→ When enabled, all FX / Current values of the effects will be
automatically reset / turned off if the sequencer is being stopped
•
Row Highlighting amount
→ Every X row in the pattern screen is highlighted
•
Pattern Scroll
→ Turn on/off scrolling in pattern. Scrolling is a nice visual gimmick but
makes editing while playing very difficult.
•
New Pattern Length
→ Defines the default pattern length of a newly created pattern
•
Default Groove Settings
→ Defines the default groove for new created patterns.
•
Show Decimal Value
– Shows the decimal value for most important hex values
•
Screensaver
→ Amount of time in minutes unused with stop sequencer after the
screensaver starts (Press
OK
to activate screensaver directly if not turned off)
•
OK to enter Screens
→ Enables automagically entering the pattern/patch/table when
pressing
OK
on a pattern number on the sequencer screen/pattern screen.
•
Confirm Seq. Stop
→ Enable confirmation to really stop the sequencer when prompted to
stop with pressing SHIFT+STOP.
•
Auto Gate on Note
→ Turn On/Off autogating. CV/Gate track: If a Note is filled in in the
pattern screen but no trigger then the Autogate function will automatically set the Gate with
the note. The gate can be reset again with a Note Off. On note changes the gate will be low
for a specified amount of micro/milliseconds until it will be set again. A value entered in the
trigger column always overrules the autogate function. If it’s turned off then no gate is
generated, except if it is entered in the Trigger columns or through other ways, not
automatically on a note.
•
Auto Gate Timeout
→ If Autogate is turned on, then this sets the time the gate is off until it
goes on again between notes.
•
Play editing FX
→ If turned off, then the current FX value beneath the cursor/editing FX in
patterns or tables will be skipped/not played. This to avoid an unintentional value change
while editing. If active an ‘X’ is shown right below in the pattern or table screen if the cursor
is on a FX value so you know this one is being skipped.
•
User Interface Setup
- Set up own color scheme and change font
•
Sega Gamepad Mapping
enters the
Calibration
Calibration and testing of all inputs and outputs.
NerdSEQ – a tracker based Eurorack sequencer
Page 86
User Manual Revision V1.26 for Firmware V1.26
12 July 2022
