Swing
adds a swing/groove to the global mainclock with a +- 1/64th precision. Please note that the
clock outputs are also affected by the swing.
Transpose
Change the global transpose in semitones/octaves higher and lower the regular pitch.
When changing the values with
SHIFT+CURSOR LEFT/RIGHT,
then the new transpose value will
be set on a zero transition of the mainclock if the sequencer if it is running. Pressing
OK
will
change the transpose value immediately. Holding
OK
while
SHIFT+ CURSOR LEFT/RIGHT
will
also change the transpose immediately.
Load Menu
Opens a file browser to load a project
Save As
Save a project. A on-screen keyboard will appear to either save the current project (just
press
OK
on the
READY
field) or enter a new project name and save it with pressing
OK
on the
READY
field. An existing project will be overwritten after a backup is being created into the backup
folder (10 iterations).
Load Sample
opens the sample-slot window.
Load Sampleblock
and
Save Sampleblock
are used to load and save complete sample blocks. A sample block are all 12
sample slots together. Here you can recall the whole block (eg replace all samples in one
go). This can also be loaded nearly seamlessly while running a sequence using a
command in the sample FX.
Sample block 000 is not supported, so every sample block must at least be named 1 and
higher.
Track Assign
enters the
screen. This is used to assign different track
types to the tracks. For example a regular CV/Gate track can be set to be a Midi track, Trigger16 ,
CV16 or any other type to use it’s dedicated functionality.
Clock IN
For the Main clock input setting. Those are:
•
Internal - Sequencer runs from the internal clock at 24ppqn internally
•
Mod. Clock24 - Sequencer runs from the Clock/Reset input with a resolution of 24ppqn
•
Mod. Clock - Sequencer runs from the Clock/Reset input with 1/16 resolution
•
Midi - Sequencer runs from external Midi Clock as follower (Midi-IO Expander / TRS-A Midi
expander module needed)
•
DIN-Sync – Sequencer runs from external DIN-Sync signals while the clock input is the Din-
Sync clock signal and the reset input is the Din-Sync run/start/stop signal. The continue
signal is not supported.
NerdSEQ – a tracker based Eurorack sequencer
Page 83
User Manual Revision V1.26 for Firmware V1.26
12 July 2022
