Xerox COLORQUBE 8570, Руководство по обслуживанию

Страница: 86 / 433

October 2012
2-40 ColorQube 8570/8870 Service Manual
92,563, 92,570, 92,579, 92,571
Revised, 3rd Revision - Xerox Internal Use Only Fault Messages and Codes
92,563, 92,570, 92,579 Electronics Module Faults
An Electronics Module error has occurred. The following troubleshooting procedure applies to
these errors.
Initial Actions
• Reboot the printer and verify the error persists.
• If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Part (Chapter 5 - Parts List)
• Electronics Module, PL 5.1 Item 1
Wiring and Plug/Jack References (Chapter 7 - Wiring Data)
• Figure 1 , System Block Diagram
• Figure 2 , Right Side Electronics Module P/J Locations
• Figure 3 , Left Side Electronics Module P/J Locations
• Figure 4 , Top Side Electronics Module P/J Locations
Procedure
Check all the Electronics Module cabling. Are the connections secure and undamaged?
Y
N
Reseat and/or replace the wiring harnesses.
Replace the Electronics Module ( REP 5.1 ).
92,571 Software Fault
A software error has occurred. The following troubleshooting procedure applies to this error.
Initial Actions
• Reboot the printer and verify the error persists.
• Check code version of the printer.
• If the problem persists, perform the following procedure.
Procedure
Check code version on the printer. Is the code latest release?
Y
N
Download the latest code.
Reset NVRAM (refer to PS NVRAM Reset in Chapter 2).
Table 1 Applicable Fault Codes
92,563 PS Version Mismatch
92,570 Interrupt Storm Fault
92,579 CDI Submit Sheet Error
Table 1 Applicable Fault Code
92,571 Software Fault