Unboxing WAZER
Please follow these instructions to properly unbox your WAZER:
1.
DO NOT tilt or flip the WAZER box.
This step requires a two-person lift. Do not attempt to tilt
the unit onto a dolly.
2. Cut the straps that wrap the box and cut the tape on the top of the box to unfold its flaps.
DO NOT make a deep cut into the box, as you will scratch the unit.
3. Cut through the cardboard from top to bottom at each corner of the box.
4. Remove the packaging that surrounds WAZER.
5. There are Accessories packed around and under WAZER; remove these and put them in a safe
place before lifting WAZER. Note that there may be some residual water in the bag from the
testing process.
6. Carefully open the bag that WAZER is wrapped in.
7. Inspect the exterior for any damage. Note that you may see some water or even some Used
Abrasive inside the cutting area; this is from quality assurance testing.
8. If you have purchased the Stand Leg Accessory, switch to those instructions at this point.
These instructions are included in the Stand Leg Accessory box. If you intend to set up WAZER
on a table or desktop then continue reading here.
9. By now, you should have selected an appropriate location for WAZER. If not, review the
Location Requirements
section of this chapter before proceeding. Improper placement of
WAZER may result in poor performance, property damage, or injury.
10.
(Two Person Lift)
With one person on each side of the unit, firmly grab the bottom of the two
aluminum hoops and move WAZER onto its desktop.
11.
Positioning for setup:
You will need access all around WAZER in order to make the necessary
connections. Do not put WAZER up against a wall at this point.
ONLY lift WAZER from the bottom of the silver aluminum hoop-shaped legs.
We recommend you to retain the packaging for return and decommissioning, if
required.
Set
tin
g Up W
AZER |
SE
C
TION 4
30
31
