RU , GSE, FOTO CONTROL, QUATROFREM v.2.53x
15. apríla 2019
Page 11 from 97
Parameter is dynamically set to the value that is inherited from another parameter (usually from the
signal type parameter).
EXAMPLE:
The condition for RELAY switching „R1 switch on [301]“ – If any parameter (e.g. Cooler
temperature [74]) is selected as „R1 Signal [189]“:
MENU \ SETTINGS \ INPUTS AND OUTPUTS \ RELAY
OUTPUTS \ Relay 1 \
MENU \ SETTINGS \ INPUTS AND OUTPUTS \ RELAY
OUTPUTS \ Relay 1 \ SPECIAL SETTING R1 \
Special source of Relay R1 switch setting
Relay R1 switches on when heatsink temperature
exceeds the set level
The condition for RELAY switching „R1 switch on [301]“ – If status word is selected as „R1 Signal
[189]“:
MENU \ SETTINGS \ INPUTS AND OUTPUTS \ RELAY OUTPUTS \ Relay 1 \ SPECIAL SETTING R1 \
Relay R1 switches on at active bite (Failure) of converter status word
Parameter to enter a password to allow access to the specific levels of converter setting
respectively to unlock some of the modes.
The password characters can be {0..9, A..Z}.
EXAMPLE:
Example of password entry
Parameter type: DYNAMIC VALUE (Linked parameter)
Name [ID]
Description
Def.
R1 switch on [301]
Conditions for R1 switch on.
Run |
MENU \ SETTINGS \ INPUTS AND OUTPUTS \ RELAY OUTPUTS \ Relay 1 \ SPECIAL SETTING \
Name and ID of the dynamic parameter
Default value of the dynamic value parameter
Parameter type: PASSWORD
Name [ID]
Description
Def.
Password
[548]
Setting the user password for access to the device settings. Password
needs to be entered when entering the converter settings.
0 *
0 * ÷ 0 *
Protects the converter settings against reconfiguration by unauthorized persons.
MENU \ SETTINGS \ CONVERTER PARAMETERS \
Basic information about the importance of the parameter
