Vicon PILOT PLUS V1544, Инструкция по установке и эксплуатации

Страница: 91 / 142

3-50
|
Chapter 3 Configuration
XX200-00 Pilot Plus
Field Description
Camera # Use this field to select which camera, from 1 – 128,
will be displayed on a monitor. Set Camera # to 0 to
blank the monitor when the salvo is called.
Preset # Use this field to select the preset position from 1- 89
to be recalled. 0 = no preset.
Recall Speed Use this field to set the speed at which the pan-and-
tilt unit will travel to the preset position. A higher
number corresponds to a faster speed. The speed
setting is only applicable for the V15UVS, V7UVS,
Surveyor Mini Dome, SVFT and V1305R-DC
receivers. Range 1 – 10.
All selections are made using the Options Wizard. To change a field’s value,
proceed as follows:
1. Select the field that you wish to modify using the Available Field
selection box. You can scroll through all available options.
2. Upon selection, the title below Available Field will change to the
parameter selected and the appropriate values will display in the
selection box.
3. Select All for all, Selected Only for an item that is highlighted in the
list or From to specify a range.
4. Click Update to implement the changes.
Note: The Settings box contains two buttons: Apply and Restore. Clicking
Apply will make the changes permanent. Clicking Restore will cancel the
changes that you have made and revert back to the original values. Once
you click Apply, you cannot restore the original values.
Default Callup Values
Default Callup Values are accessed using the Monitor Displays screen. Refer
to the
Monitors section in this chapter for a full description of the screen.