3-76
|
Chapter 3 Configuration
XX200-00
Pilot Plus
Camera/Monitor Partitions
Video from cameras may not be displayed on monitors unless the cameras
are partitioned to those monitors. Select a monitor from the list and then use
the onscreen buttons to move from the partition list (Selected monitor can
see these cameras) to the non-partitioned list (Selected monitor cannot see
these cameras).
For example, as shown above, monitor 1 can display cameras 1 through 128.
If you only want cameras 1 through 10 to display on monitor 1, select
cameras 11 through 128 and click the Remove button to move those
cameras to the Selected Monitor can Not see these cameras list. If you wish
to move all or some of the non-partitioned cameras back to the Selected
Monitor can see these cameras list, click the Add or Add All buttons. When
you have made your choices for the monitors click the Apply button.
If a camera is removed from a monitor, all settings associated with that
camera, i.e. default callup, salvo switch, alarms, etc. are also removed and
have to be reapplied if the camera is partitioned to the monitor again.
Note:
The Settings box contains two buttons: Apply and Restore. Clicking
Apply will make the changes permanent. Clicking Restore will cancel the
changes that you have made and revert back to the original values. Once
you click Apply, you cannot restore the original values.
Содержание PILOT PLUS V1544
