Vicon PILOT PLUS V1544, Инструкция по установке и эксплуатации

Страница: 21 / 142

2-4
|
Chapter 2 Installation and Operation
XX-200-00 Pilot Plus
unit. To install the tilt stand and bumper feet, select the following from the
Accessory Kit:
ƒ
Tilt Stand and Feet Kit 1291304205
ƒ
Bumper Feet 8000811801
1. Locate the screw holes on the underside of the unit.
2. Line up the right mounting foot shown below with the screw holes and
attach it to the unit with the supplied hardware.
3. Insert one end of the tilt stand into the groove of the installed right
mounting foot. Insert the other end of the tilt stand into the left mounting
foot and position the left mounting foot over the left set of screw holes.
Attach it to the unit with the supplied hardware.
4. Remove the adhesive backing from the bumper feet and attach them
approximately 12 inches apart and approximately 1 inch from the rear
panel.
Attaching the Mounting Ears and Handles
The mounting ears are used to attach the unit to a rack. The handles allow
the unit to be easily slid in and out of the rack, if drawer mounted. Install the
mounting ears and handles as follows:
1. Attach the mounting ears, part number 1298530501 to each side of the
unit using the 10-32 X 3/8 black pan head screws, part number
8003733401.
2. Attach the handles, part number 1298531301 to the mounting ears using
the 8-32 X 1/2 flat head screws part number 8003736101.