Installation
|
2-7
Pilot Plus
XX200-00
Camera Connection
Note:
Refer to the
Cable Recommendations
section in the
Maintenance
chapter for information on the type of cables to be used for video connection.
Up to 128 cameras may be connected to the unit. Connect each camera by
routing a properly terminated coaxial cable between each camera and the
unit. Unused BNC connectors must be terminated with a 75 ohm terminator.
Cameras may be looped to other devices, such as a DVR, using the
V15RCB-24 cable (optional, available from Vicon). Each looping BNC
connector is labeled from A to H. The camera input numbers correspond to
the BNC letters as shown in the table that follows.
V15RCB-24 BNC Label
Cable for
Cameras
A B C D E F G H
1-8
8 7 6 5 4 3 2 1
9-16
16 15 14 13 12 11 10 9
17-24
24 23 22 21 20 19 18 17
25-32
32 31 30 29 28 27 26 25
33-40
40 39 38 37 36 35 34 33
41-48
48 47 46 45 44 43 42 41
49-56
56 55 54 53 52 51 50 49
57-64
64 63 62 61 60 59 58 57
65-72
72 71 70 69 68 67 66 65
73-80
80 79 78 77 76 75 74 73
81-88
88 87 86 85 84 83 82 81
89-96
96 95 94 93 92 91 90 89
97-104
104 103 102 101 100 99 98 97
105-112
112 111 110 109 108 107 106 105
113-120
120 119 118 117 116 115 114 113
121-128
128 127 126 125 124 123 122 121
Содержание PILOT PLUS V1544
