Vicon PILOT PLUS V1544, Инструкция по установке и эксплуатации

Страница: 26 / 142

Installation
|
2-9
Pilot Plus XX200-00
Pin # Name
1 RESP IN +
2 RESP IN -
3 GND
4 COM OUT-
5 COM OUT+
6 GND
6. Connect the terminal block plug into the KEYPAD terminal block.
Receiver Connection
Note: Refer to the Cable Recommendations section in the Maintenance
chapter for information on the type of cables to be used for twisted-pair
connection.
The Pilot Plus is compatible with the Vicon V12xx; V13xx; Dome; Vicoax®;
and Simplex receivers. You can also connect the receivers to the Vicon
V1400X-IDL series Intelligent Distribution Line Control and connect the IDL to
the Pilot Plus.
Receivers may be connected in either duplex or simplex mode. Duplex
operation requires the use of both command and response lines. Response
signals are used to transmit information such as the activation of alarms and
communication failures to the Pilot Plus. Command signals, which send
control information from the Pilot Plus to the receiver, are always required.
Simplex operation requires the use of command lines only. The operating
mode must be chosen (or determined, for existing installations) before the
following procedure can be performed.
Connect the receivers or IDL to the RECEIVERS terminal block as follows:
1. Select the 6-Position Terminal Block Plug, part number F004802508 from
the Accessory Kit.
2. Route the appropriate wires from the receiver or IDL to the unit.