Vicon PILOT PLUS V1544, Инструкция по установке и эксплуатации

Страница: 79 / 142

3-38
|
Chapter 3 Configuration
XX200-00 Pilot Plus
Field Description
Monitor # All alarm monitors that are enabled are listed. The
video from any camera may be displayed on any
monitor for the specified alarm, if the camera has been
partitioned to the monitor. Refer to the
Monitors
section for more information. Select the monitor (1 – 8)
that you wish to associate with the alarm input
number.
Note: Monitor entries will be rejected if the camera is
not partitioned to that monitor. Set to Monitor = 0 to
change camera.
Camera # All cameras are listed. Select the camera (1 – 128)
that you wish to have displayed on the monitor you
selected in the Monitor # column for the alarm input.
Note: Camera entries will be rejected if the camera is
not partitioned to that monitor. Set to Camera = 0 to
change monitor.
Aux_1 Use this field to program an auxiliary relay contained
in a receiver to respond to an alarm input and provide
a control output.
Choices are: N/C, On and Off.
Preset # Used to select a preset position that may be recalled
for each camera. Enter 1 to 89 to recall the preset
number stored in the receiver.
0 = No Preset.
All selections are made using the Options Wizard. To change a field’s value,
proceed as follows:
1. Select the field that you wish to modify using the Available Field
selection box. You can scroll through all available options.
2. Upon selection, the title below Available Field will change to the
parameter selected and the appropriate values will display in the
selection box.
3. Select All for all, Selected Only for an item that is highlighted in the
list or From to specify a range.
4. Click Update to implement the changes.
Note: The Settings box contains two buttons: Apply and Restore. Clicking
Apply will make the changes permanent. Clicking Restore will cancel the